| The XAP® 800 audio management and distribution platform has set new standards for audio conferencing performance. With eight microphone inputs, a microphone mixer, echo and noise cancellation, advanced audio processing and filters, it manages microphones and speakers, as well as local and auxiliary audio. Connect up to eight XAP 800s to use 64 individual microphones at once. |
| |
ClearOne XAP 800 Specifications |
| Audio Performance |
| Conditions | Unless otherwise specified, all measurements are performed with a 22 Hz to 22kHz BW limit (no weighting) |
| Frequency Response | 20 Hz to 20 kHz ±1 dB |
| Noise (EIN) | -126 dBu, 20 kHz BW, max gain, Rs = 150˛ |
| THD+N | <0.02% |
| SNR | 80 dB re 0 dBu, (A-weighted) |
| Dynamic Range | 100 dB (A-weighted) |
| Crosstalk | <-91 dB re 20 dBu @ 20 kHz channel to channel |
| Auto Mixer |
| Parameters | Number of Open Microphones (NOM) |
| PA Adaptive Mode |
| First Mic Priority Mode |
| Last Mic Mode |
| Maximum # of Mics Mode |
| Ambient Level |
| Gate Threshold Adjust |
| Off Attenuation Adjust |
| Hold Time |
| Decay Rate |
| Matrix Mixing |
| Parameters | 32 x 32 matrix |
| 12 analog in/out |
| 12 expansion bus in/out |
| 8 assignable processing blocks in/out |
| Assignable Processing Blocks |
| Filters | All pass |
| Low pass |
| High pass |
| Low shelving |
| High shelving |
| Parametric EQ |
| Notch |
| CD Horn |
| Crossovers | Bessel |
| Butterworth |
| Linkwitz-Riley |
| Compressor |
| Delay adjustable up to 500 ms |
| Microphone Input |
| Configuration | Input Gain Adjust |
| Mic or Line Level |
| Phantom Power on/off |
| Echo Cancellation on/off |
| Noise Cancellation on/off |
| Filters | All Pass |
| Low Pass |
| High Pass |
| Notch |
| PEQ |
| Mute | on/off |
| Chairman Override | on/off |
| AGC | on/off |
| Speech Leveler | on/off |
| Auto Gate / Manual gate | |
| Adaptive Ambient | on/off |
| Mic/Line Inputs 1-8 |
| Push-on terminal block, balanced, bridging |
| Impedance | 5 k˛ |
| Nominal Level | adjustable -55 dBu, -25 dBu, 0 dBu |
| Maximum Level | -35 dBu, -5 dBu, +20 dBu |
| Echo Cancellation | 130 ms tail time (works with 12 dB of room gain) |
| Noise Cancellation | 6–15 dB attenuation |
| Phantom Power | 24 V, selectable |
| Line Inputs 9-12 |
| Push-on terminal block, balanced, bridging |
| Impedance | >10 k˛ |
| Nominal Level | 0 dBu |
| Maximum Level | 20 dBu |
| Outputs 1-12 |
| Push-on terminal block, balanced |
| Impedance | 50 ˛˛ |
| Nominal Level | 0 dBu |
| Maximum Level | 20 dBu |
| Expansion Bus In/Out |
| Proprietary Network | RJ-45 (2), 115.2 kbps, 110k ˛ impedance |
| Category five twisted-pair |
| Maximum cable length between any two units | 80' (24 metres) |
| RS-232 |
| Type | DB-9 female 9,600/19,200/38,400 |
| Default | 57,600 baud rate; 8 bits, 1 stop, no parity Hardware flow control on (default)/off |
| Control/Status |
| Type | DB25 female A/B (2) Inputs A/B:active low (pull to ground) |
| Outputs A/B | open collector, 40 VDC max, 40 mA each +5 VDC pins (2) (300 mA over-current protected) |
| Remote Panels A/B |
| 4-pin push-on terminal block |
| RS-485 proprietary protocol Category five twisted-pair cable |
| 1 pair data, 1 pair power and ground +15 VDC (300 mA over-current protected) |
| Set-up Software |
| G-Ware |
| Power |
| Input Range | Auto-adjusting |
| 100–240 VAC; 50/60 Hz |
| Power Consumption | 30 W typical |
| Dimensions (L x D x H) | 17.25" x 10.25" x 1.75" |
| 43.8 x 26 x 4.5 cm |
| Weight | 7 lb/3.2 kg dry |
| 12 lb/5.5 kg shipping |
| Operating Temperature | 32 to 100° F/0 to 38° C |
| Humidity | 15% to 80%, non-condensing |
| Approvals | FCC, CSA, IC, CE, NOM, ACA, SABS, JATE |
)
